Prepare your DTF files for a clean print

Image requirements

For the best print quality:

• Upload PNG files with a transparent background.
• Use 300 DPI for sharp, high quality prints.
• Make sure your artwork is clear and not blurry.

Every file is reviewed before printing to make sure it meets our quality standards. We make requested enhancements or adjustments when needed.

Gang sheet sizes

Every gang sheet is 22 inches wide. Length runs from 12 inches up to 240 inches.

Pressing instructions

You will need: the DTF transfer, a heat press or home iron, your garment, and a Teflon sheet or parchment paper.

1. Heat. Heat press: 290 to 300°F. Home iron: cotton or the highest heat setting.

2. Position. Lay the garment flat. If you are using a gang sheet, cut the designs apart first. Place the transfer printed side down where you want the design.

3. Press. Cover with Teflon or parchment paper. Heat press: 15 to 20 seconds. Home iron: press firmly for about 2 minutes.

4. Peel. Let it cool briefly, then peel from one corner while still warm.

5. Finish. Check the design has fully adhered. Press again for a few seconds if needed. Let the garment cool completely before wearing or washing.

Washing and care

• Wash with cold water
• Turn the garment inside out before washing
• Do not bleach
• Do not dry clean
• Air dry recommended

Our quality guarantee

Misprint or quality issue? Contact us and we will send a free replacement. Our transfers are built to last 50+ washes without fading or peeling.